Completes Projects Fast: Requires only 20-30 minutes of clamp time, fully cured in 24 hours
Use Indoors or Outdoors: Passes ANSI/HPVA Type II water resistance
Versatile: Ideal for use on hardwoods, softwoods, and natural wood composites
Dries Natural Color: Offering a natural bond line
Gorilla Wood Glue,a PVA glue, offers the benefits of an easy-to use, water-based adhesive, withGorilla strength. It is incredibly water resistant and versatile, making itgreat for both indoor and outdoor wood working projects.
Directions:
Application
Forbest results, it is essential that the wood surfaces are prepared prior to applicationof glue. For laminating, the surfaces should be planed smooth, leaving theboard surface free from machine marks, tear-out and snipes. Also, be careful toavoid burnishing and end snipes. Just how much Gorilla Wood Glue to applydepends on many factors. In general, apply a generous amount of glue on one ofthe surfaces. On hard-to-glue woods, apply the glue on both surfaces. Rubtogether with the other surface to distribute the glue evenly on both surfaces.Enough glue should be applied so that a fine bead of glue squeeze-out willoccur when clamping. Coverage: 1 gallon of Gorilla Wood Glue will cover about200 square feet. 1 fluid ounce will cover approximately 1.6 square feet.
Clamping
Thetechnique and type of clamp to be used is determined by many factors: thespecific type of joint, type of stock or lumber, moisture content of stock,room temperature, assembly time and surface quality. In general, apply enoughpressure that will cause a fine bead of glue to squeeze out when the properpressure is applied.
ClampingTime (amount of time pressure needs to remain applied): 20–30 minutes forroom temperature applications. The temperature must be above 55°F. Note thatclamping time can be dependent on temperature, humidity, and the porosity ofthe wood.
CureTime (amount of time for glue to reach total bonding strength): 24 hours
Clean Up
Cleanup while glue is wet: Use a clean, damp cloth to wipe off excess glue.Make as many passes as needed with the clean area of the cloth to remove allthe glue. When areas have completely dried, sand as needed. Wash hands, skinand damp cloths in soap and warm water, then rinse.
Cleanup when glue has dried: Use a sharp putty knife, razor, or sharp scraperto shave hardened glue from surface, then sand as needed. Soak hands and skinin soap and warm water, wash, then rinse.
Cleaningthe bottle tip: Use a clean, damp cloth to wipe off excess glue afterclosing. If tip becomes clogged with dry glue, remove the cap and push the clogbackwards with a toothpick, then rinse cap with warm water.
Toremove Gorilla Wood Glue from hands, wash with warm soap and water.
Technical Specs:
APPLICATION TEMPERATURE – 55° to 75° F, best at roomtemperature
SERVICE TEMPERATURE – 0° to 150° F
OUTDOOR – Yes, under covered area
MOISTURE RESISTANT – Water resistant – not recommended forcontinual water exposure
PAINTABLE – Yes
SANDABLE – Yes
STAINABLE – No
EXPANDS WHEN CURED – No
CURED COLOR – Natural tan wood color
TECHNICAL STANDARDS – ANSI/HPVA Type II
STORAGE TIPS –Store at room temperature.Wipe excess glue from spout and keep sealed.
